Products Specifications:
Spray Gun Material: Aluminum Alloy
Cup Material: PVC plastic
Type:High Volume Low Pressure
Fluid Nozzle: 1.4mm, 1.7mm, 2.0mm
Air Consumption: 14.5CFM
Operating Pressure: 2-3.5 bar
Pattern Width: 160-240mm
Hopper Size: 10CM Diameter
Air Inlet: 1/4 inch
Cup Capacity: 600cc
Before First Use
NOTICE: Before first use, clean the
Spray Gun thoroughly.

If not removed, the material used for testing and corrosion prevention will contaminate paint.

Spraying Technique
CAUTION: DO NOT STOP WHEN SPRAYING.

Spraying materials will start to set and dry.as soon as they come in contact with the air.

They will cause a permanent clog if not cleared.immediately.If discontinuing spraying for more than half an hour, turn off the air supply, disconnect Cup from Gun Body and thoroughly rinse Cup and Gun Body with fresh, clean water.

Paint Preparation and Filling
Note:Proper paint mixture is essential. Follow the manufacturer’s directions. Most paints will spray easily if they are thinned properly.

1. Thread the Cup to the Gun Body and tighten until the Cup is securely in place.

2. Thin the paint according to manufacturer’s directions and mix thoroughly.

3. Carefully strain the paint through a paint strainer or a piece of cheesecloth.